After your IP Phone is installed, you can configure it to work remotely, accessing the features
of your office voice network using the teleworker service of the MiVoice Border Gateway.

For all MiNet IP Phones in the 69xx series:
  • Press Settings. A list of Menu options appear. The default is Status.
  • Select Voice Services, the Teleworker Settings screen is displayed.
  • Select MiVoice Border Gateway.
  • Enter the IP Address and press Save.
  • Press Close in the Static Settings screen.
Your IP Phone is now ready to be used remotely. 

For MiNet IP Phones in the 5xxx series:
Press and hold the 7 key, and plug the powered network cable (or DC adapter cord) into the power
input. Hold the 7 key until the CONFIGURE TELEWORKER prompt appears on the phone's display
screen (this takes approximately 4 seconds).

Find the Group to which your phone belongs:
 Group 1
 Group 2
 
 5020
 5212
 5320e
 5215
 5215 Dual Mode
 5330
 5220
 5220 Dual Mode
 5330e
 
 5224
 5340
 
 5235
 5340e
 
 5304
5360 
 
 5312
Navigator 
 
 5324
 5540 IP Console
 
 5320
5560 IPT 
For Group 1 sets:
  • Press # for Yes. USE PRESENT SETTINGS? appears on the display screen.
  • Press #for Enter. TELEWORKER GATEWAY appears on the display screen.
  • Enter the MBG IP Address using the # key to insert decimals if required, and then press the down arrow key (▼). STORE IN NVRAM appears on the display screen.
  • Press # to save. The "SAVING TO NVRAM, DO NOT REMOVE POWER" message displays. The phone reboots and the time and date display.
    • If ENTER TW INSTALL PW displays, enter your Installer Password.
    • If the IP phone has not been previously registered on an ICP, the system displays USE SUPERKEY TO SEND PIN. Enter your PIN number and press the Superkey.
For Group 2 sets:
  • Press * for Yes. DELETE/NEW SETTINGS appears on the display screen.
  • Press # for New.
    • On 53xx series sets, IP ADDRESS TYPE appears on the display screen. Press * for IPV4 or # for IPV6. TELEWORKER GATEWAY appears on the display screen.
    • On all other Group 2 sets, TELEWORKER GATEWAY appears on the display screen.
  • Enter the MBG IP Address using the # key to insert decimals if required, and then press the down arrow key (▼) (the Vol- key on the 5560 IPT). STORE CHANGES? appears on the display screen.
  • Press * for Yes.
    • If ENTER TW INSTALL PW displays, enter your Installer Password.
    • If the IP Phone has not been previously registered on an ICP, the system prompts you to send a PIN number by pressing either the Superkey or the Hold key, depending on phone model, as shown:
 Phone Model
 System Prompt
 5212, Dual Mode 5215, Dual Mode 5220, 5224, 5312, 5324
 Use Superkey to SEND PIN
 5235, 5304, 5320, 5320e, 5330, 5330e, 5340, 5340e, 5360, Navigator, 5540 IP Console, 5560 IPT
 Use Hold Key to SEND PIN
  • Enter your PIN number and press the appropriate key

Your IP Phone is now ready to be used remotely.